Adtech ADT-DK300A - Page 125

BZ001M056A ADT‐DK300A/400A Engraving Machine

116
1:negativedirection

101 
Xrestrainacc(mm/s^2)
102 
Yrestrainacc(mm/s^2)
103 
Zrestrainacc(mm/s^2)
104 
4restrainacc(mm/s^2)
105 
Xmaxrestrainrate
106 
Ymaxrestrainrate
107 
Zmaxrestrainrate
108 
4maxrestrainrate
Range : 1~90000
Unit :
Authority : SuperAdmin
Default : 90000
Effectivetime : Instant
Note : 1. Used to configure the restriction acceleration of every axis during
pretreatmentprocessing.
2. No matter which parameter, the lower the setting is, the slowerthe
processingspeedis;viceversa.
3.Thesettingvalueshouldbeashighaspossibleifeachaxispermits.
4. In comprehensive parameter P1.58 (interpolation speed mode), this
parameterisvalidifitissetto1;thedefaultsettingisin valid.
109  Xlockbrakesignalenable
Range : 0~1
Unit : None
Authority : SuperAdmin
Default : 0
Effectivetime : Instant
Note : Usedformechanicalsystemcontrol,suchasheavyload.
0:Invalid
1:On
110  Ylockbrakesignalenable