Adtech ADT-DK300A - Page 131

BZ001M056A ADT‐DK300A/400A Engraving Machine

122
infowhileprogramisrunning.
This parameter is dedicated for programmers, and the users are not
suggestedusingthisparameter.
Ifthetestinginfoisenabled,thesystemperforma ncewillbelowered,and
thereforeitisdisabledduringnormalprocessing.
If networking is enabled, this function must be disabled, or else
 the
networkingwillfail.

020  axiscontrolcomposite
Range : 0~1
Unit : None
Authority : Superuser
Default : ON/1
Effectivetime : Instant
Note : Usedtoconfigurewhetherthekeyforaxismotiononthecontr olpanelis
enabled.
Thisparameterisusedtoshieldthecompositefunctionofthekeyforaxis
motionontheNCpanelandreduce  thepossibilityofmisoperationwhen
additional panel is used. However, if no additional panel is used, this
parameter must be enabled, or else the axis motion can’t be controlled
throughthekey.

021  additionalpanelenable
Range : 0~1
Unit : None
Authority : Superuser
Default : OFF/0
Effectivetime : Instant
Note : Usedtoconfigure whetherNC usesadditionalpanel,whichmustbeADT
matching additional panel, or compatible with the interface of same
protocol.
If additional panel is used, the system testing info enable must be
deactivated(P3.19).

022  Mmacroprogramselection<●>
Range : MFUNC(M),User‐Def
Unit : None