BZ001M056A ADT‐DK300A/400A Engraving Machine
123
Authority : Superuser
Default : MFUNC(M)
Effectivetime : Instant
Note : Used to configure the auxiliary control of the system by calling
M_FUNC.NC or not. Through M_FUNC.NC fi le, the user can custom M
code function and panel control function. If this par amet er is set to
User‐Def,
specificfunctionscanbeachievedthroughM_FUNC.NCprogram
fileunderD:\MACROdirectory.
023 Tmacroprogramselection<●>
Range : TFUNC(M),User‐Def
Unit : None
Authority : Superuser
Default : TFUNC(M)
Effectivetime : Instant
Note : Thisparametercanbeusedtodefinethetoolmagazineprogram.TFUNC
(M)isthebuilt‐intoolmagazineprogramofthesystem.Ifthisparameteris
set to User‐Def, the
tool magazine function can be achieved by writing
M_FUNC.NCunderD:\MACROdirectory.
024 PLCprogramselection<●>
Range : PLC(M),User‐Def
Unit : None
Authority : Superuser
Default : PLC(M)
Effectivetime : Instant
Note : UsedtoconfiguretheauxiliarycontrolofthesystembycallingPLC(M).NC
ornot.
025 Screensaveron
Range : 0&1
Unit : None
Authority : Superuser
Default : 0
Effectivetime : Instant
Note : Usedtoconfigur ewhetherturnonscreensaverofthesystem,inorderto
furtherreducesystempowerconsumption.
Ifthe parameteris setto 1,the screendisplaywillautomaticallyturn off
afteroneminutewhenthesystemisstopped.
To Next Page
Loading...
