Adtech ADT-DK300A - Page 138

BZ001M056A ADT‐DK300A/400A Engraving Machine

129
therotationdirectlylater,whilethecontrollerwilloutputcorresponding
analogvoltageaccordingtolinearscaleautomatically.

022 
Spi.GearNumerator
023 
Spi.GearDenominator
Range : 1~65535
Unit : None
Authority : Operationadminorhigher
Default : 1
Effectivetime : Instant
Note : Iftheprincipalaxishasgearposition,pleasesetthehardwaregearratio
tothisparameter,whichhasn’tbeenusedinstandardversion,butmay
beusedincertainspecial
conditions.
024  Spi.EncoderLogicDir
Range : 0~1
Unit : None
Authority : Operationadminorhigher
Default : 0
Effectivetime : Instant
Note : Thedirectionofrotationofthespindleencoder.
025  Spi.OpenDelayTime(ms)
Range : 0~9000
Unit : Ms
Authority : Operationadminorhigher
Default : 6000
Effectivetime : Instant
Note : Set the delay time through this parameter to start the spindle. The
parameterismainlytopreventprocessingbeforethespindleisstarted.

026 
Servospindlereadylevel
027 
Servospindlequasistopin‐placelevel
028 
Servospindlezerospeedin‐placelevel
029 
Servospindlespeedarrivallevel
Range : 0~1
Unit : None
Authority : Operationadminorhigher