Section 4 User Interface Guide Total Access 600R System Manual
112 © 2002 ADTRAN, Inc. 61200600L1-1A
SECURITY > FILTERS > INTERFACES (ETH[1])
Define the filters for the Ethernet interface from this menu.
SECURITY > FILTERS > INTERFACES (ETH[1]) > SUB-INTERFACE
The Ethernet sub-interface is 802.3[1.0]. This is a read-only field.
SECURITY > FILTERS > INTERFACES (ETH[1]) > SET-UP
Enable the Ethernet interface filtering and define filters from this menu.
END
the last filter to combination.
AND
logically AND this filter with the next filter in the list.
OR
logically OR this filter with the next filter in the list.
IN FROM VC
The packets which come into the unit can be filtered in three ways:
DISABLE (DEF)
Turns off packet input filtering. No incoming packets are blocked.
BLOCK ALL
All incoming packets from the WAN are blocked except as defined
in the
SECURITY > FILTERS > INTERFACES > SETUP > IN EXCEPTIONS
list.
FORWARD ALL
No incoming packets from the WAN are blocked except as defined
in the
SECURITY > FILTERS > INTERFACES > SETUP > IN EXCEPTIONS
list.
IN EXCEPTIONS
This is a list of up to 32 filter entries which can be combined using the operations field. The
operations are performed in the order they appear on the list.
#
Indicates the entry number in the In Exceptions table.
ACTIVE
Turns this entry active when set to YES. Default is NO.
T
YPE
Selects the filter define list to reference (default is MAC):
To Next Page
Loading...
Need help?
General
