ADTRAN Total Access 600R System Manual

Total Access 600R System Manual Section 4 User Interface Guide
61200600L1-1A © 2002 ADTRAN, Inc. 91
SERV ADDR
(This option is only available when NAT PORT TRANSLATION is enabled.) This is the
destination of the packet.
PROTO
(This option is only available when NAT PORT TRANSLATION is enabled.) This shows the
protocol used (
TCP, UDP, ICMP, etc.).
PRIV PORT
(This option is only available when NAT PORT TRANSLATION is enabled.) This is the
private port used for the entry.
SPOOF PORT
(This option is only available when NAT PORT TRANSLATION is enabled.) If the same
private port is already used in the table, it will spoof a different port for the entry.
SERVER PORT
(This option is only available when NAT PORT TRANSLATION is enabled.) This port is used
on the public side.
TIME
(This option is only available when NAT PORT TRANSLATION is enabled.) This is the time
since the entry was last used.
IN CNT
(This option is only available when NAT PORT TRANSLATION is enabled.) This is the
number of packets that came in.
OUT CNT
(This option is only available when NAT PORT TRANSLATION is enabled.) This is the
number of packets sent out.
NAPT ADDRESS
(This option is only available when NAT PORT TRANSLATION is enabled.) This represents the
public address that is being used as the NAPT address. Read-only.
ENTRY COUNT
(This option is only available when NAT PORT TRANSLATION is enabled.) This is the number of
entries in the NAT table. Maximum is 1500.
ENTRY OVERFLOW COUNT
(This option is only available when NAT PORT TRANSLATION is enabled.) This is a count of the
dropped entries due to entry count being 1500 or greater; i.e., the NAT table is full.

ADTRAN Total Access 600R Specifications

General

Brand	ADTRAN
Model	Total Access 600R
Category	Network Router
Language	English