OPTION 006 Avionics
Annex-B-2
Fig. B-10 Marker beacon mode selection menu......................................................... B-12
Fig. B-11 VOR mode operation.................................................................................. B-12
Fig. B-12 VOR mode operation with peak deviation selection (screen 1)................. B-13
Fig. B-13 VOR mode operation with peak deviation selection (screen 2)................. B-13
Fig. B-14 REF selected............................................................................................... B-14
Fig. B-15 VOR made operation with "Coupling" enabled ......................................... B-14
Fig. B-16 Ident/Comms selected.................................................................................B-15
Fig. B-17 ADF mode selection menu......................................................................... B-16
Fig. B-18 SEL-CAL mode selection menu................................................................. B-16
Fig. B-19 SEL-CAL tones utility................................................................................B-17
Fig. B-20 SEL-CAL tone entry................................................................................... B-17
Fig. B-21 ILS functional test set-up............................................................................ B-29
Fig. B-22 Oscilloscope trace for a 0% DDM waveform. ........................................... B-30
Fig. B-23 Spectrum analyzer trace for a 0% DDM waveform................................... B-30
Fig. B-24 Oscilloscope trace for a 40% DDM waveform. ......................................... B-31
Fig. B-25 Spectrum analyzer trace for a 40% DDM waveform................................. B-31
Fig. B-26 Oscilloscope trace for a 150 Hz dominant waveform. ............................... B-32
Fig. B-27 Spectrum analyzer trace for a 150 Hz dominant waveform....................... B-32
Fig. B-28 Accuracy of SDM signal path test set-up................................................... B-33
Fig. B-29 Equipment configuration for DDM waveform accuracy............................ B-35
Fig. B-30 9.96 kHz sub-carrier with frequency modulation....................................... B-37
Fig. B-31 Waveform phase control test set-up ........................................................... B-38