REMOTE OPERATION COMMON COMMANDS
4-14
*OPT?
Description: Reads hardware options present. If no options are present a single ‘0’ is returned,
otherwise the response is up to six strings separated by commas.
Parameters: None
Response: <arbitrary ASCII response data>
Options
Returned values: Option 001 – No Attenuator
Option 002 – Mechanical Attenuator
Option 003 – Electronic Attenuator
Option 005 – Dual-Channel ARB
Option 006 – Pulse Modulation
Option 007 – Rear Panel Outputs
Option 008 – Real-Time Baseband
Option 009 – Differential IQ
Option 010 – List Mode
Option 020 – 2G CDMA License
Option 021 – 2G & 3G CDMA License
*RST
Description: Resets the instrument to a known configuration appropriate for remote operation: see
page 3-156.
Parameters: None
*SRE
Description: Sets the service request enable register. This is an eight-bit register.
Parameters: <NRf>
Mask
Valid values: Mask: integer. Valid values are 0 to 255. Values outside range are rejected and an error
is generated.
*SRE?
Description: Reads the service request enable register. This is an eight-bit register.
Parameters: None
Response: <NR1>
Mask
Returned values: Mask: integer. Values are in the range 0 to 255.
To Next Page
Loading...
