Aeroflex 3412 - RF Output Frequency Commands; Carrier Frequency, Phase, Sweep

4-33
RF output frequency commands
([SOURce]:FREQuency subsystem)
Carrier frequency, phase, sweep
Commands for:
• Setting carrier frequency, phase, phase reference, phase noise optimization and sensitivity
• Setting carrier frequency mode
• Setting carrier frequency step size
• Setting carrier sweep mode operating frequency
• Setting carrier sweep step size, spacing and mode
• Setting carrier sweep stop and start frequencies.
[SOURce]
:FREQuency
[:CW|:FIXed]\?
:STEP
[:INCRement]\?
:MODE\?
:PHASe
[:ADJust]\?
:OPTimisation\?
:REFerence\?
:SENSitivity\?
:SWEep
:DWELl\?
:MANual
:SPACing\?
:STARt\?
:STEP
[:LINear]\?
:LOGarithmic\?
:STOP\?