LOCAL OPERATION GETTING STARTED
3-19
Introduction
Using steps
1 Press
KNOB/
STEP
to disable the rotary control adjustment (the bracket under the carrier frequency
disappears).
2 Press
. Scroll down to Increment using the navigation key. Enter the size of
frequency step using the numeric keypad, and terminate with the [MHz], [kHz] or [Hz] key.
The instrument now uses this new value of step size.
3 Press
SIG
GEN
to return to the main screen.
4 Now press the
x10
and
10
keys repeatedly and note how the displayed carrier frequency
changes in steps of the increment that you have just set. Holding either of these keys
pressed provides continuous stepping.
5 In the same way as for rotary control operation, you can check the current amount of offset
from the reference carrier frequency by pressing
.
And that’s about it!
These few pages have shown you the fundamentals of operating the instrument — which apply
throughout the manual. We hope and believe that you will find operation intuitive and simple.
If you need help, just refer back to these pages.
To Next Page
Loading...
