INSTALLATION
2-12
Routine safety testing and inspection
Aeroflex’s products are tested prior to delivery to ensure that they comply with the requirements
of IEC 61010-1 (BS EN61010-1). We advise that products are routinely inspected and tested to
ensure that they have no faults and continue to meet their specifications.
Safety critical components should only be replaced with equivalent parts, using techniques and
procedures recommended by Aeroflex.
Aeroflex designs and constructs its products in accordance with International Safety Standards
such that in normal use they represent no hazard to the operator. Aeroflex reserves the right to
amend the above information in the course of its continuing commitment to product safety.
Cleaning
Before starting any cleaning, switch off the instrument and disconnect it from the supply.
Case exterior: use a soft cloth moistened with water to clean the case; do not use aerosol or liquid
solvent cleaners.
Touch screen: take care not to scratch the touch-panel overlay during use or when cleaning.
Clean the touch panel by wiping a slightly damp, soft, lint-free cloth gently over the surface.
Putting into storage
If you are putting the instrument into storage, ensure that the following conditions are maintained:
Temperature range: −40 to 71°C (−40 to 163°F)
Pressure 570 mbar (4570 m/15 000 ft)
To Next Page
Loading...