Aeroflex 3412 - Default Settings

QUICK REFERENCE DEFAULTS
3-156
Default settings
The instrument reverts to the factory default settings:
• At power-on (unless you have stored a different power-on memory location — see page 3-142)
• After a Preset Instrument operation (page 3-143)
• After the
*
RST command.
Table 3-2 Default settings
Carrier frequency:
Step :
(Maximum available) 2 GHz/3 GHz/4 GHz/6 GHz
1 kHz
RF level:
Step:
−140 dBm (0 dB for Option 001 no attenuator)
1 dB Status: OFF
Modulation mode: Internal FM, modulation disabled
Modulations: FM1: Deviation: 0 Hz, ON
Internal source, frequency: 1 kHz, sine
FM2: Deviation: 0 Hz, ON
Internal source, frequency: 400 Hz, sine
ΦM1: Deviation: 0 rad, ON
Internal source, frequency: 1 kHz, sine
ΦM2: Deviation: 0 rad, ON
Internal source, frequency: 400 Hz, sine
AM1: Deviation: 0%, ON
Internal source, frequency: 1 kHz, sine
AM2: Deviation: 0%, ON
Internal source, frequency: 400 Hz, sine
Pulse: ON
External source:
AC coupled, 50 Ω
MOD ON/OFF ON
SOURCE ON/OFF ON for all modulation parameters
Modulation steps:
∆FM 1 kHz, ∆ΦM 0.1 rad, ∆AM 1%
Mod frequency steps: 10 Hz
Carrier sweep:
Freq mode:
Mode:
Type:
Ext trigger:
Start:
Stop:
Step size:
Time:
Fixed
Single sweep
Linear
Off
250 kHz
(Maximum available)
1 kHz
50 ms