Aeroflex 3412 - Page 265

REMOTE OPERATION AM COMMANDS
4-55
[SOURce][:MODulation]:AM[1]|2:INTernal:FREQuency:SWEep
:DWELl
Description: Sets the time per sweep step for AM.
Parameters: <numeric_value>
Valid values: <NRf>(ms) | MAXimum | MINimum
*RST sets: 50 ms
[SOURce][:MODulation]:AM[1]|2:INTernal:FREQuency:SWEep
:DWELl?
Description: Queries the time per sweep step for AM.
Parameters: None
Response: <NR2>
Returned values: Dwell time in ms
[SOURce][:MODulation]:AM[1]|2:INTernal:FREQuency:SWEep
:MANual
Description: Sets a new AM frequency whilst a sweep is paused.
Parameters: <numeric_value>
Valid values: <NRf>(Hz) | MAXimum | MINimum | UP | DOWN
Set by value, to maximum or minimum, or stepping up or down.
This command is available only when AM[1]|2:INTernal:MODE SWEep is selected,
and sweep operation is not in progress (PAUSED or WAITING FOR TRIGGER). The
frequency value should be limited to the range determined by
AM[1]|2:INTernal:SWEep:STARt and AM[1]|2:INTernal:SWEep:STOP.
[SOURce][:MODulation]:AM[1]|2:INTernal:FREQuency:SWEep
:MANual?
Description: Queries the AM frequency set during a paused sweep.
Parameters: None
Response: <NR2>
Returned values: AM frequency in Hz