REMOTE OPERATION CALIBRATION COMMANDS
4-174
CALibration:IQUSer:ADJust
Description: Performs a user IQ calibration at the current settings.
CALibration:IQUSer:MODE
Description: Sets whether user IQ calibration is done at a spot frequency; over a band; over up to
four bands; or at the frequencies set up for list mode operation.
Parameters: <CPD>
Valid values: SPOTfreq | SPANfreq | MULTiband | LISTfreq
CALibration:IQUSer:MODE?
Description: Queries whether user IQ calibration is done at a spot frequency; over a band; over up to
four bands; or at the frequencies set up for list mode operation.
Parameters: None
Response <CRD>
Returned values: SPOT | SPAN | MULT | LIST
CALibration:IQUSer:MULTi:BAND:STARt
Description: Sets the band number and start frequency for the user IQ calibration.
Parameters: <NRf>,<NRf>
<band number>,<frequency>
Valid values: <0, 1, 2, 3>,<NRf> (Hz)
CALibration:IQUSer: MULTi:BAND:STARt?
Description: Queries the start frequency for a particular band used for user IQ calibration.
Parameters: <band number>
Response <NR2>
Returned values: Start frequency in Hz
To Next Page
