Agilent 1200 Series Autosampler Reference Manual 245
Theory of Operation 8
LAN Communication Interface Board
The following cards can be used with the Agilent 1200 Series modules.
NOTE
One board is required per Agilent 1200 Series stack. It is recommended to add the LAN
board to the detector with highest data rate.
NOTE
The LAN board can only be used together with:
a main board version G13XX-66520 (for G1315A, G1365A, G1314A, G1310A, G1311A,
G1312A and G1329A) or newer and on all other Agilent 1200 Series modules.
a DOS-ChemStation software revision A.06.01 or above.
Table 45 LAN Boards
Type Vendor Supported networks
G1369A
G1369-60001
Agilent Technologies Fast Ethernet, Ethernet/802.3, RJ-45 (10/100Base-TX)
recommended for re-ordering
J4106A (*) Hewlett Packard Ethernet/802.3, RJ-45 (10Base-T(
J4105A (*) Hewlett Packard Token Ring/802.5, DB9, RJ-45 (10Base-T)
J4100A (*) Hewlett Packard Fast Ethernet, Ethernet/802.3, RJ-45 (10/100Base-TX) + BNC (10Base2)
NOTE
These cards (*) may be longer orderable. Minimum firmware of these Hewlett Packard
JetDirect cards is A.05.05.
To Next Page
General
