Agilent Technologies 6890 Series - Using Run Time Events

169
Instrument Automation
Using run time events
Using run time events
The [Run Table] key is used to program timed events.
You can control the following events during a run.
• Valves (1-8)
• Multiposition valve
• Signal type (see page 150)
• Analog signal zero, attenuation, and range
• Digital signal zero and baseline level shifts (see page 157)
• Auxiliary pressures (3, 4, 5)
• TCD negative polarity (on/off)
•NPD H
2
flow (on/off)
• Pausing (freezing) and resuming a signal value