Instrument Automation
Using clock time events
174
Using clock time events
The Clock Table function allows you to program events to occur
during a day based on the 24-hour clock. Clock table events that would
occur during a run or sequence are ignored.
For example, the clock table could be used to start an analysis before
you even get to work in the morning.
Procedure: Programming clock time events
1. Press [Clock Table] to access the clock time control table.
The following message will be displayed if no events are
programmed.
2. Press [Mode/Type] to view the clock time program types.
These only show if the instrument
is equipped with valves.
To Next Page
Loading...
Need help?
General
