The Keyboard and Display
[Status]
28
[Status]
The [Status] key has two tables associated with it. You switch between them by
pressing the key.
The Ready/Not Ready status table
This table lists parameters that are Not Ready or gives you a Ready for Injection
display. If there are any faults, warnings, or method mismatches present, they are
displayed here. See chapter 12 for detailed information about the not ready, fault, and
warning status displays. The method mismatch displays are discussed in chapter 8,
“Methods”.
Ready for injection display
Not ready display
Ready display—check for warnings.
Not ready—items that are not ready.
If you have a not ready display, check
for faults or warnings.
Fault—a hardware problem requiring
user intervention.
Warning—problems that user should
be aware of but that will not prevent
instrument from executing a run.
Method mismatch—message appears
configuration has changed after
loading a method or power on.
if hardware or user-entered
To Next Page
Loading...
Need help?
General
