Instrument Automation
The run table
172
Procedure: Editing events in the run table
1. Press [Run Table].
2. Move the cursor to the event you want to change.
3. To edit the time for an event, move the cursor to the line
labeled Time. Type the desired time and press [Enter].
4. To edit a setpoint value, scroll to the setpoint item and press
the [On] or [Off] key or enter a numeric value for the setpoint.
Press [Enter].
Procedure: Deleting run time events
1. Press [Run Table] to access the run time table.
2. From within this table press the [Delete] key to delete events
from the run time table. Pressing [Delete] while in an existing
time event table produces the following display.
3. Press [Enter] to delete the current timed event; press
[Clear] to cancel this operation.
To Next Page
Loading...
