The Keyboard and Display
Short-cut keys [Temp], [Pres], [Flow], [Det Control], [Ramp #]
26
[Ramp #]
With a control table open that has no temperature, flow, or pressure ramps,
[Ramp #] plus a number opens the Oven control table. If no ramps are specified,
the cursor is on the Rate 1 (off) line.
With a control table that contains temperature, flow, or pressure ramps,
[Ramp #] (1-6) moves the cursor to the first line of the ramp number specified.
If the ramp number does not exist, the cursor goes to the highest ramp number
in the control table.
Press [Ramp # [2]
Oven control table opens. Because no
temperature ramps are set on this table,
cursor is on the Rate 1 (off) line.
[Col 1] table open, cursor on Pressure
line. Press [Ramp #] [2]
Cursor moves to Rate 2 line.
To Next Page
Loading...
Need help?
General
