225
Analytical Sequences
Defining a sequence
Procedure: Storing a sequence
1. Press [Store][Seq] to open the Store Sequence control table.
2. Enter an identifying number for the sequence.
3. Press [Enter] to store the sequence.
If the sequence number you specified already exists, you will be prompted to
either:
• Overwrite the existing sequence, which will replace the existing sequence
with the new sequence
• Cancel the store and return to the STORED SEQUENCES status table.
Sequences can also be stored from within the STORED SEQUENCES status
setpoint table by scrolling the cursor to the appropriate sequence number and
pressing the [Store] key.
To Next Page
Loading...
