Messages Part 1. Not Ready messages
Temperature zone not ready
240
Table 25, continued
Temperature zone not ready
Oven temp
The GC is not ready to begin a run until the oven temperature is within ±1 degree
of the setpoint for the equilibration time. The GC is not ready if the oven is not
turned on.
If the oven is unable to reach the setpoint, the GC remains not ready indefinitely
unless the oven temperature is out of the oven range, which will cause a
shutdown.
Other heated zones
The GC has a number of heated zones in addition to the oven. These are inlets,
detectors, and auxiliary, or “aux,” zones. The GC is not ready to start a run until
Status message Run log entry Comments
Other not ready messages
Diagnostics mode Not ready:
Diagnostics active
See page 244.
Test in progress Not ready:
Test in progress
A diagnostic test is in progress.
Wait until it is completed.
Front injector Not ready:
Front injector
Back injector Not ready:
Back injector
Host system Not ready:
Host system
See page 244.
External device An device connected to the
Remote Start connector is not
ready.
Power on in progress Power-on restart:
Blank run
See page 245.
To Next Page
Loading...
Need help?
General
