261
Part 4. Fault messages Messages
Table 28, continued
Fault no. Status message Popup message Run log Comments
271 B inlet bad cksum Back inlet: invalid module
checksum
272 F det bad cksum Front detector: invalid
module checksum
273 B det bad cksum Back detector: invalid
module checksum
274 Pneu aux bad cksum Pneu aux module: invalid
module checksum
275 F inlet bad fact cal Front inlet: invalid
constants from factory
calibration
276 B inlet bad fact cal Back inlet: invalid
constants from factory
calibration
277 F det bad fact cal Front detector: invalid
constants from factory
calibration
278 B det bad fact cal Back detector: invalid
constants from factory
calibration
279 P aux bad fact cal Pneumatics aux invalid
constants from factory
calibration
280 F inlet i/o failure
281 B inlet i/o failure
282 F det i/o failure
283 B det i/o failure
284 Pneu aux i/o failure
285 F det adjust failure Front detector offset
adjustment failed
Not ready:
F det adjust failure
286 B det adjust failure Back detector offset
adjustment failed
Not ready:
B det adjust failure
To Next Page
Loading...
Need help?
General
