Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide 15
Recalling Default Setups 229
Performing a Secure Erase 229
18 Print (Screens)
To print the oscilloscope's display 231
To set up network printer connections 232
To specify the print options 234
To specify the palette option 235
19 Utility Settings
I/O Interface Settings 237
Setting up the Oscilloscope's LAN Connection 238
To establish a LAN connection 239
Stand-alone (Point-to-Point) Connection to a PC 240
File Explorer 241
Setting Oscilloscope Preferences 243
To choose "expand about" center or ground 243
To disable/enable transparent backgrounds 244
To load the default label library 244
To set up the screen saver 244
To set AutoScale preferences 245
Setting the Oscilloscope's Clock 246
Setting the Rear Panel TRIG OUT Source 246
Performing Service Tasks 247
To perform user calibration 248
To perform hardware self test 250
To perform front panel self test 251
To display oscilloscope information 251
To display the user calibration status 251
To Next Page
Loading...
