19
Chapter 1: Outline of the DPS12
4. Use the [CURSOR] key or the [SHUTTLE] dial to move the underline to the second character
position.
While the [NUMBER/NAME] key’s LED is flashing, you can move the underline back and forth using the
[CURSOR] key or the [SHUTTLE] dial.
5. Repeat Steps 3 and 4 to complete naming.
If you enter a wrong character, use the [CURSOR] key or the [SHUTTLE] dial to move the underline to the
character you wish to correct.
6. Press the [NUMBER/NAME] key again.
This time, the [NUMBER/NAME] key functions as an [ENTER] key. The [NUMBER/NAME] key’s LED turns
off, and the entered characters are confirmed. If you wish to cancel the entered character, press the [SOLO]
key (which functions as a [CANCEL] key) to return to the previous display.
■ Entering characters directly (character field)
You can enter characters directly into a character field by using the keys on the top panel.
1. Use the [CURSOR] key to move the cursor to a character field.
2. Press the [NUMBER/NAME] key.
The [NUMBER/NAME] key’s LED flashes, and the keys on the top panel function as number/letter keys.
Alphabets, numbers, and symbols are printed below the keys. The following characters can be entered.
3. Press the key that corresponds to an alphabet, number, or symbol you wish to enter.
The character that corresponds to the pressed key is entered and the underline moves to the right.
4. Repeat Step 3 repeatedly to complete naming.
5. Press the [NUMBER/NAME] key again.
This time, the [NUMBER/NAME] key functions as an [ENTER] key. The [NUMBER/NAME] key’s LED turns
off, and the entered characters are confirmed. If you wish to cancel the entered character, press the [SOLO]
key (which functions as a [CANCEL] key) to return to the previous display.
To Next Page
Loading...
Need help?
General
