E18C Door Phone Administrator Guide
AKUVOX SMART INTERCOM www.akuvox.com
6.3. LED Setting
6.3.1. Configure Card Reader LED Setting
You can enable or disable the LED lighting on the card reader area as needed
on the web interface. Meanwhile, If you do not want to have the LED light on
the card reader area to stay on, you can also set the timing for the exact time
span during which the LED light can be disabled in order to reduce the
electrical power consumption. Path: Device > Light > LED of Swiping Card
Area.
Parameter set-up:
Enabled: Tick the check box if want to enable the card reader LED lighting
and vice versa.
Start Time - End Time (H): enter the time span for the LED lighting to be
valid, e.g. if the time span is from 18-22 it means LED light will stay on
during the time span from 6:00 pm to 10:00 pm during one day (24
hours).
Note:
When the check box is unticked , the parameters related to NTP
server will become uneditable.
To Next Page
Loading...
Need help?
General
