E18 Door Phone Administrator Guide
7.
Network Setting
7.1. Device Network Connection Setting
You can configure the default DHCP mode (Dynamic Host Configuration
Protocol) and static IP connection. More over, you can set up IP address,
Subnet Mask, Default Gateway, and DNS servers.
Parameter Set-up:
DHCP: select the DHCP mode by moving the toggle switch to the right.
DHCP mode is the default network connection. If the DHCP mode is
turned on, then the door phone will be assigned by the DHCP server with
IP address, subnet mask, default gateway, and DNS server address
automatically.
Static IP: select the static IP mode by checking off the DHCP check box.
When static IP mode is selected, then the IP address, subnet mask,
default gateway, and DNS servers address have to be manually
configured according to your actual network environment.
IP Address: set up the IP Address if the static IP mode is selected.
Subnet Mask: set up the subnet Mask according to your actual network
To Next Page
Loading...
Need help?
General
