E18 Door Phone Administrator Guide
8.1.2.IP Call Configuration
You are required to set up a specific port the for the data transmission for the
IP calls. Path: Intercom > Basic > Direct IP.
Parameter set-up:
Enabled : tick the checkbox to enable or disable the direct IP call . For
example if you do not allow direct IP call to be made on the device, you
can disable the function.
Direct IP Port: the direct IP Port is “5060” by default with the port range
from 1-65535. And you enter any values within the range other than the
5060, you are required to check if the value entered is consistent with the
corresponding value on the device you wish to establish a data
transmission with.
8.2. SIP Call &SIP Call Configuration
SIP calls (Session Initiation Protocol ) are established and supported by SIP
servers. If the two intercom devices want to initiate SIP calls with each other,
then they should be registered in the same SIP server. And SIP call
parameters related to its account, server, and transport type need to
configured first before you can make calls on the device.
You can make SIP call ( Session Initiation Protocol ) in the same way as you
do for making the IP calls on the device. However, SIP call parameters related
to its account, server, and transport type need to configured first before you
can make calls on the device.
To Next Page
Loading...
Need help?
General
