E18 Door Phone Administrator Guide
of the function etc. Path:Access Control > Body Temperature > Measuring
Body Temperature.
Parameter set-up:
Mode: select either “Disabled” Mode “Wrist” or “Forehead” Mode for
temperature measurement according to your need. The device can be
installed with digital forehead and wrist temperature detector therefore
you are required to set the mode properly according to your application.
Mask Detection: select ” Disable” if you want to turn off the mask
detection. Select “ Set mask-wearing as mandatory” and the device will
check if the visitor is wearing a mask or not while reminding the visitor
with the announcement “Please wear a mask” . select “ Display
mask-wearing prompt” and the device will display mask-wearing prompt
only without making the the mask-wearing mandatory. Warning alarm
will be triggered when the body temperature measured is detected higher
than the defined normal body temperature.
Normal Body Temperature: set the body temperature to the predefined
body temperature as the measuring basis in either Fahrenheit or Celsius.
For example if you set the temperature 37.3 degree Celsius as the normal
To Next Page
Loading...
Need help?
General
