Parameters Set-up:
Account status: Check to see if the SIP account is registered or not.
Account Active: Click “enable” or “Disable” to activate or deactivate the
registered SIP account.
Display Name: Configure the name, for example the device’s name to be
be shown on the device being called to.
User Name: Enter the user name obtained from SIP account administrator
Account: Select the exact account (Account 1/2) to be configured.
Display Label: Configure the device label to be shown on the device
screen.
Register Name: Enter the SIP account register Name obtained from the
SIP server.
Password: Enter the password obtained from the SIP server.
5.4.2.2. SIP Server Configuration
Two SIP severs can be set up for device in order to achieve call session
through SIP sever between intercom devices. SIP sever 2 serves as a backup
to the SIP sever 1.
To do the setup, please do as follows :
To Next Page
Loading...
Need help?
General
