5. Set the time schedule and limit for the RIFD card access.
6. Change the “Card Issuing” in the Card Status to “Normal”.
7. Click Submit tab for validation and Cancel tab for cancellation.
Parameters Set-up:
Card Status: Select “Car Issuing” in the field before adding the RFID
card and change the status back to “Normal” after the card is added.
IC key DoorNum: Select the relay switch available for the RIFD card door
access.
IC Key Tags: Select the frequency of the validity the RFID card for the
door access among three options: “Allow” “Schedule” and
“ Forbidden” For example, if you select “Allowed” then the card is
always valid for unlimited door access according to your setting. If you
select “Schedule” you are required to set up the specific time of the RFID
card access validity. If you select “Forbidden” then the RFID card will never
To Next Page
Loading...
Need help?
General
