Generic Commands
Page 464 7450 ESS System Mangement Guide
as the operational state of any entities contained within. Many objects must be shut down before they
may be deleted.
The no form of this command administratively enables an entity.
Default no shutdown
Special Cases log-id log-id — When a log-id is shut down, no events are collected for the entity. This leads to the
loss of event data.
accounting-policy accounting Policy — When an accounting policy is shut down, no accounting
data is written to the destination log ID. Counters in the billing data reflect totals, not increments,
so when the policy is re-enabled (no shutdown) the counters include the data collected during
the period the policy was shut down.
app-route-notifications
Syntax app-route-notifications
Context config>log
Description Specific system applications in SR OS can take action based on a route to certain IP destinations
being available. This CLI branch contains configuration related to these route availability
notifications. A delay can be configured between the time that a route is determined as available in
the CPM, and the time that the application is notified of the available route. For example, this delay
may be used to increase the chances that other system modules (such as IOMs/XCMs/MDAs/XMAs)
are fully programmed with the new route before the application takes action. Currently, the only
application that acts upon these route available or route changed notifications with their configurable
delays is the SNMP replay feature, which receives notifications of route availability to the SNMP
trap receiver destination IP address.
cold-start-wait
Syntax [no] cold-start-wait
Context config>log>app-route-notifications
Description The time delay that must pass before notifying specific CPM applications that a route is available
after a cold reboot.
Default no cold-start-wait
Parameters — Values seconds: 1 – 300
Default 0
To Next Page
Loading...
