Event and Accounting Logs
7450 ESS System Mangement Guide Page 465
route-recovery-wait
Syntax [no] route-recovery-wait
Context config>log>app-route-notifications
Description The time delay that must pass before notifying specific CPM applications after the recovery or
change of a route during normal operation.
Default no route-recovery-wait
Parameters — Values seconds: 1 – 100
Default 0
event-control
Syntax event-control application-id [event-name | event-number] [generate][ severity-level]
[throttle] [specific-throttle-rate events-limit interval seconds | disable-specific-throttle]
event-control application-id [event-name | event-number] suppress
no event-control application [event-name | event-number]
Context config>log
Description This command is used to specify that a particular event or all events associated with an application is
either generated or suppressed.
Events are generated by an application and contain an event number and description explaining the
cause of the event. Each event has a default designation which directs it to be generated or
suppressed.
Events are generated with a default severity level that can be modified by using the severity-level
option.
Events that are suppressed by default are typically used for debugging purposes. Events are
suppressed at the time the application requests the event’s generation. No event log entry is generated
regardless of the destination. While this feature can save processor resources, there may be a negative
effect on the ability to troubleshoot problems if the logging entries are squelched. In reverse,
indiscriminate application may cause excessive overhead.
The rate of event generation can be throttled by using the throttle parameter.
The no form of the command reverts the parameters to the default setting for events for the
application or a specific event within the application. The severity, generate, suppress, and throttle
options will also be reset to the initial values.
Default Each event has a set of default settings. To display a list of all events and the current configuration use
the event-control command.
To Next Page
Loading...
