Rockwell Automation Publication 1756-UM535D-EN-P - November 2012 49
Design an Enhanced Redundancy System Chapter 2
Firmware Requirements
If you are using an enhanced redundancy system, use only enhanced redundancy
system firmware. These are the enhanced redundancy system firmware-revision
bundles:
• 16.054Enh
• 16.080Enh
• 16.081Enh
• 16.081_kit1
• 19.052Enh
• 19.053Enh
• 19.053_kit1
• 20.054
• 20.054_kit1
To download the most recent enhanced redundancy system firmware bundle, go
to http://www.rockwellautomation/support.com.
Software Requirements
These sections describe required and optional software for use with your
enhanced redundancy system.
Required Software
This software is required to use all enhanced redundancy system revisions:
• RSLogix 5000 software.
• RSLinx Classic communication software.
• Redundancy Module Configuration Tool (RMCT) - This utility is
installed when you install RSLinx Classic communication software.
For the most current software versions, go to http://www.rockwellautomation/
support.com.
To Next Page
Loading...