Allen-Bradley Series B

A–B
A
Appendix
A–1
Default Settings
The decoder has a set of default conditions. These conditions may be
restored by scanning the Default Configuration, configuration bar code
symbol. The details of the default configuration are as follows:
Function Default
Bar Code
Symbol
Escape
Sequence
Tab
Enter Configuration Mode
–
•
Show Configuration
–
• •
Exit Configuration Mode
–
•
Disable Decoding
Disabled
•
Getting
Reset
–
• •
Getting
Started
Default Configuration
Factory Set
•
Store Configuration
–
•
ROM/RAM Self Test
Enabled Auto
•
Code Selection
All Codes
• •
Check Character Verification (Code 39, I 2 of 5)
Disabled
• •
Check Characters (Code 11)
1
• •
Check Character Transmission (Code 39, I 2 of 5)
Disabled
• •
Minimum and Maximum Length Checking (Code 39,
Codabar, Code 128, Code 11)
1, 32
• •
Minimum and Maximum Length Checking (I 2 of 5)
4, 32
• •
UPC/EAN Options
Disabled
• •
Code
Selection
Codabar Start/Stop Character Transmission
Enabled
• •
Selection
Code 39 Full ASCII Conversion
Disabled
• •
Code ID Character Assignment
Code 39a
I 2 of 5b
UPC/EANc
Codabard
Code 128e
Code 11f
• •
Code ID Character Transmission
Disabled
• •
Default Settings