Allen-Bradley Series B

Chapter 6
Programming Via Configuration Bar Code Symbols
6–21
Serial Number
A unique serial number, up to 10 digits, can be stored in
each decoder. Serial numbers can consist of numbers,
characters, or any combination of the two.
Numbers and characters must be scanned from the
character menu.
The default serial number is 00000000.
Transmit
or
Serial Number =
Enter
Message =
Characters from
Character Menu
End Of Characters
Exit
No–Read
Message ON
Enter
Character from
Character Menu
End Of Characters
Exit
No–Read Recognition
If no–read recognition is enabled and a bar code symbol was
scanned but not decoded, the no–read message is
transmitted, the Valid Read LED and speaker will be pulsed
twice.
The number of characters can vary from 0 to 10.
* Default is
No–Read Recognition OFF.
The default no–read message is none (empty buffer).