Chapter 6
Programming Via Configuration Bar Code Symbols
6–4
configuration session by scanning the Enter Configuration Mode symbol
again to clear the error and then begin scanning the first symbol in the
configuration sequence.
As long as each configuration operation is individually completed,
configuration operations may be carried out independently. There is no
constraint against moving from category to category while configuring
separate items. However, you may not interrupt a Type 2 or a Type 3
configuration to begin another. If this is attempted, a syntax error will occur,
the second configuration operation will be ignored, and you will have to
recover from the syntax error to continue the interrupted configuration
operation as described previously.
Syntax Error Example
For example, suppose you scan the Trailer = symbol, and then the UPC Only
symbol. Since the decoder was expecting a character argument, it responds
with a syntax error.
You may correct the error by scanning the following configuration bar code
symbols:
• Enter Configuration Mode
• Trailer =
• Character symbols from the character menu
• End Of Characters
To Next Page
Loading...
