Chapter 6
Programming Via Configuration Bar Code Symbols
6–24
Laser Shutoff Delay
The laser shutoff delay determines how long the laser will remain ON
while the trigger is enabled. The laser will remain on until a read is
completed, the laser shutoff period has elapsed, or the trigger has been
disabled.
Regardless of the laser shutoff delay time, the laser will always be turned
off when the trigger is released (unless the
Trigger Latch Mode
function is
enabled).
If the delay is set to 0, the laser will not turn on at all when triggered.
*Default is 120 sweeps.
Enter
Exit
Laser Shutoff
Delay
Trigger Latch Mode
When enabled, the laser is turned on when triggered, but is not shut off
immediately when the trigger is disabled. The laser will remain on until a
read is completed or the laser shutoff period has elapsed.
Note: This must be enabled when using a Catalog No. 2755–L2
scanner with a package detector. This allows the scanner to continue
scanning until the laser shutoff delay elapses, or a good read occurs.
*Default is trigger latch mode enabled.
Enter
Exit
Enable/Disable
Trigger Latch
Mode
To Next Page
Loading...
