230 Rockwell Automation Publication 1560F-UM001A-EN-P - June 2019
Appendix A Parameter Information
334 Restart Auto Bit Value 0/1 All disabled Volt Unbal
Overvoltage
Undervoltage
Line Loss
Modifies the Auto Restarting of the selected faults so that the
restart is attempted when the fault condition is removed rather
than after a fixed time delay.
R/W
335 DLX Input 1 -2^31/2^31 0 General purpose parameter used as an input to the DeviceLogix
Engine.
R/W
336 DLX Input 2 -2^31/2^31 0 General purpose parameter used as an input to the DeviceLogix
Engine.
R/W
337 DLX DL Input 1 0/159999 1 General purpose datalink used to select another parameter
within the SMC-50 as an input to the DeviceLogix Engine.
R/W
338 DLX DL Input 2 0/159999 1 General purpose datalink used to select another parameter
within the SMC-50 as an input to the DeviceLogix Engine.
R/W
339 DLX DL Input 3 0/159999 1 General purpose datalink used to select another parameter
within the SMC-50 as an input to the DeviceLogix Engine.
R/W
340 DLX DL Input 4 0/159999 1 General purpose datalink used to select another parameter
within the SMC-50 as an input to the DeviceLogix Engine.
R/W
341 DLX DL Input 5 0/159999 1 General purpose datalink used to select another parameter
within the SMC-50 as an input to the DeviceLogix Engine.
R/W
342 DLX DL Input 6 0/159999 1 General purpose datalink used to select another parameter
within the SMC-50 as an input to the DeviceLogix Engine.
R/W
343 DLX Output 1 -2^31/2^31 0 General purpose parameter that can be written by the
DeviceLogix engine and monitored from a HIM or network
device.
R
344 DLX Output 2 -2^31/2^31 0 General purpose parameter that can be written by the
DeviceLogix engine and monitored from a HIM or network
device.
R
345 DLX Command Ready
Enable
Disable
Allows the user to enable or disable the DeviceLogix engine.
Once the "Enable" or "Disable" command has been executed
the parameter will automatically revert back to "Ready".
R/W
346 DLX Status Enable
Disable
Indicates the current state of the DeviceLogix engine. R
347 Load Type 0/1
[Motor]
Resistive
Allow choice of Motor Load or Resistive Heater Load
-Motor Load
-Resistive Heater Load
R/W
Table 66 - SMC -50 Parameter List (Continued)
Number Name Unit Min/Max Default Enum Text Description R/W