Allied Telesis AT-9724TS User Manual

3. After changing the route preference value for a specific routing protocol, that protocol needs to be restarted because the previously learned routes
have been dropped from the Switch.The Switch must learn the routes again before the new settings can take effect.
To view the
Route Preference Settings window, click Configuration > Layer 3 IP Networking > Route Preference Settings:
Figure 6- 92. Current and New Route Preference Settings window
The following fields can be viewed or set:
Parameter Description
RIP (1-999)
Enter a value between 1 and 999 to set the route preference for RIP.The lower the value, the higher the chance
the specified protocol will be chosen as the best path for routing packets.The default value is 100.
OSPF Intr
a (1-999)
Enter a value betw
een 1 and 999 to set the r
oute pr
ef
er
ence for
OSPF Intr
a
.
The lo
w
er the value
,
the higher the
chance the specified protocol will be chosen as the best path for routing packets.The default value is 80.
STATIC (1-999) Enter a value between 1 and 999 to set the route preference for Static.The lower the value, the higher the
chance the specified protocol will be chosen as the best path for routing packets.The default value is 60.
OSPF Inter (1-999) Enter a value between 1 and 999 to set the route preference for OSPF Inter.The lower the value, the higher the
chance the specified protocol will be chosen as the best path for routing packets.The default value is 90.
OSPF ExtT1 (1-999) Enter a value between 1 and 999 to set the route preference for OSPF ExtT1.The lower the value, the higher
the chance the specified protocol will be chosen as the best path for routing packets.The default value is 110.
OSPF ExtT2 (1-999) Enter a value between 1 and 999 to set the route preference for OSPF ExtT2.The lower the value, the higher
the chance the specified protocol will be chosen as the best path for routing packets.The default value is 115.
Click
A
pply
to implement changes made
.
99
Allied Telesyn AT-9724TS High-Density Layer 3 Stackable Gigabit Ethernet Switch

Allied Telesis AT-9724TS Specifications

General

MAC address table	16000 entries
Packet buffer memory	2 MB
Maximum data transfer rate	88 Gbit/s
Full duplex	Yes
Dimensions (WxDxH)	440 x 210 x 44 mm
Power requirements	100-240V AC/50-60Hz
Management platform	SNMP, RMON
Networking features	IEEE 802.3 10T Ethernet, IEEE 802.3u 100TX Ethernet, IEEE 802.3ab 1000T Ethernet, IEEE 802.3z 1000X Ethernet
Connectivity technology	Wired
DHCP features	DHCP client
Security algorithms	SSH
Switch type	Managed
Switch layer	L3+
SFP/SFP+ slots quantity	4
Basic switching RJ-45 Ethernet ports quantity	24
Memory type	SDRAM / Flash
Flash memory	16 MB
Internal memory	256 MB
Power consumption (typical)	90 W
Certification	UL 1950 FCC Class A CSA 22.2 No. 950 EN55022 Class A EN 60950 (TUV) EN50082-1 CE
Storage temperature (T-T)	-25 - 55 °C
Operating temperature (T-T)	0 - 40 °C

Weight and Dimensions

Weight	3200 g