Settings
36
System
Network Here, you can set either to acquire an IP address by DHCP or manually
configure a fixed IP. By default, the AP is set to obtain IP address by
DHCP.
If you change the IP address, communication with this product will
be disconnected. Some data may be lost in the transition. To
continue the configuring or monitoring the status of the AT-TQ5403,
please log back into your management session with the updated IP
address.
Select DHCP Server
When "DHCP" is selected for the “Connection Type" field in the Settings >
System > Network window, refer to Figure 13.
Figure 13. Settings > System > Network - “DHCP” Selection
The fields are defined in Table 11 with Connection Type set to “DHCP”.
Table 11. Settings > System > Network - “DHCP” Selection
Item Name Description
Host Name Enter 1 to 63 single-byte alphanumeric
characters and hyphens. You cannot use
hyphens at the beginning or end. The Host
Name is displayed in the title bar of the Web
browser.
The factory default is “AT-TQ5403”.
To Next Page
Loading...
