AT-TQ5403 Access Point User’s Guide
37
If you update or change any of these parameters, click the SAVE &
APPLY button to save and update your configuration.
Select Static IP
When "Static IP" is selected for the “Connection Type" field in the Settings
> System > Network window, refer to Figure 14.
Figure 14. Settings > System > Network - “Static IP” Selection
The fields are defined in Table 12 with Connection Type set to “Static IP”.
Connection Type Select “DHCP”.
The factory default value is “DHCP”.
NOTE: For the “Static IP” selection in
Figure 14 and Table 12.
DNS Name Server Specify the DNS name server address. If it is
blank, it uses the address obtained from the
DHCP server.
The factory default is blank.
Table 12. Settings > System > Network - “Static IP” Selection
Item Name Description
Host Name Enter 1 to 63 single-byte alphanumeric
characters and hyphens. You cannot use
hyphens at the beginning or end. The Host
Name is displayed in the title bar of the Web
browser.
The factory default is “AT-TQ5403”.
Table 11. Settings > System > Network - “DHCP” Selection (Continued)
Item Name Description
To Next Page
Loading...
Need help?
General
