Settings
48
If you update or change any of these parameters, click the SAVE &
APPLY button to save and update your configuration.
Table 18. Settings > System > Log Window
Item Name Description
Severity
From the pull-down menu, select the severity level forth data reported
in the log - one of eight levels. For example, if you set the importance
level to "Critical (2)", important events "Emergency (0)" - "Critical (2)"
are recorded.
The factory default setting is "Informational (6)".
Severity Level Severity Description
Emergency (0) System unusable
Alert (1) State that must be dealt with immediately
Critical (2) Serious condition
Error (3) Error occurred
Warning (4) Warning conditions exist
Notice (5) Normal but need attention
Informational (6) Information message
Debug (7) Debug level message
Log Relay Select "Enabled" to transfer the log to the specified host, or select
"Disabled" to not transfer the log to a host.
The factory default is "Disabled".
Host Enter the IP address or host name (FQDN) of the host to transfer the
host log.
The factory default is blank.
(Example) 10.10.1.200, syslog.yourdomain.com.
NOTE: FQDN is a concatenation of labels (character strings) with
periods. Half-width alphanumeric characters and hyphens can be used
for each label. The first digit is allowed. A hyphen can not be used at
the beginning or the end of each label. The number of characters for
each label is 63 characters or less. The total number of characters of
the FQDN, including the period, is 253 characters or less.
Port Set the port number of the host to which the port log is transferred with
1 to 65535.
The factory default is "514".
To Next Page
Loading...
Need help?
General
