AT-TQ5403 Access Point User’s Guide
59
is set to 60 and 64, the operation will be as follows. Channel 60 will
stop transmission/reception if it detects radar. The access point will
attempt to change to 64. If 64 also detects radar, then all candidate
channels can not be used. 30 minutes after stopping 60, the access
point attempts to resume using 60. If radar is not detected on
channel 60 after 1 minute, then transmission/reception on channel
60 is started.
Detection status of weather radar can be confirmed by checking the
"DFS" field of the Monitoring > Status > Radio2 window.
Basic Settings
You can configure the Radio2 Basic Settings in the Settings > Radio >
Radio2 > Basic Settings window. Refer to Figure 27.
Figure 27. Settings > Radio > Radio2 > Basic Settings Window
The fields are defined in Table 26 for the Settings > Radio > Radio2 >
Basic Settings window.
Table 26. Settings > Radio > Radio2 > Basic Settings Window
Item Name Description
Country Code Your Country Code is displayed in this field.
Status Sets whether to transmit and receive radio waves. Select "Enabled" to
turn Radio2 on and transmit and receive radio waves.
Select "Disabled" to turn Radio2 off and not transmit and receive radio
waves.
The factory default is "Disabled".
To Next Page
Loading...
Need help?
General
