Settings
38
If you update or change any of these parameters, click the SAVE &
APPLY button to save and update your configuration.
Time Configuring the time for the AT-TQ5403 can be done manually or by using
network time protocol (NTP).
It is recommended to use NTP when using multiple products with
this product. In the case of manual setting, the AT-TQ5403 time
progressively deviates from the correct date and time as time
progresses. With multiple products involved, the difference in date
and time between products also increases.
The AT-TQ5403 hardware does not have a real-time clock function
backed up by batteries. When the system time is set “Manually” and
the power is turned OFF or is restarted, the access point System
Time is returned to the factory default time (Jan 1 00: 00: 00 2018) .
Connection Type Select “Static IP”.
The factory default value is “DHCP”.
See for the “DHCP” selection in Figure 13 on
page 36 and Table 11.
Static IP Address Specify the IP address. You can configure
this field to an IP address of your choosing.
The factory default is "192.168.1.230".
Subnet Mask Specify the subnet mask. You can configure
this field to a subnet mask address of your
choosing.
The factory default is "255.255.255.0".
Default Gateway Specify the factory default gateway. You can
configure this field to a gateway address of
your choosing.
The factory default is "192.168.1.254".
DNS Name Server Specify the DNS name server address.
The factory default is blank.
Table 12. Settings > System > Network - “Static IP” Selection
Item Name Description
To Next Page
Loading...
Need help?
General
