IV-36
Setting cutoff length
Set the length of pieces to be cut by using the head-end positioning
function as described below.
1 Move the cursor to the ST. field with the cursor keys, and call the
station whose cutoff length is to be set.
NOTE
O Use a station from the stations 1 to 99, and set the quantity of pieces to
be cut at the same time.
2 Press the ENT key to set the station number in the ST. field and
move the cursor to the L field.
3 Enter the cutoff length in the range of 5.0 to 9999.9 mm {0.197 to
99.999 in.} with the numeric keys, and press the ENT key to set the
cutoff length in the L field and move the cursor to the P field.
The kerf of the saw blade is automatically added to the cutoff
length.
NOTE
O If the cutoff length is 10 mm {0.394 in.} or less, contact AMADA.
4 Enter the quantity of pieces to be cut in the range of 1 to 9999 with
the numeric keys, and press the ENT key to set the quantity of
pieces to be cut in the P field and move the cursor to the ST. field.
To Next Page
Loading...
