IV-44
STOPPING AUTOMATIC OPERATION
When the machine falls into such a condition that it cannot continue
cutting during its automatic operation, press the EMERGENCY STOP
button. The entire machine, including the saw blade and hydraulic unit,
comes to an immediate stop.
The machine stops as soon as the AUTO/MANUAL switch is turned to
MANUAL during its automatic operation. If the machine is cutting the
work, it stops after completing and counting the current cut.
When the alarm code “E-007” is displayed at the occurrence of a runout
alarm, the machine comes to an immediate stop. (See “Alarm code
list” in Part V, Troubleshooting.)
The machine also stops as soon as it falls into an alarm condition or its
power is turned off.
When the machine has stopped in emergency, its automatic operation
cannot be resumed by pressing the BLADE DRIVE button. Investigate
and remove the cause of the emergency stop, and restart the automatic
operation of the machine from the beginning.
NOTE
O When restarting the automatic operation of the machine after its emergency
stop, pay attention to the quantity displayed in the C field. The work is not
cut for the pieces already counted.
To Next Page
Loading...
