I-10
HFA-400 and HFA-400W machines
Round work
(diameter)*
420 mm {16.54 in.}
Single
cutting
Rectangular work
(H × W)*
415 × 415 mm {16.34 × 16.34 in.}
400 × 400 mm {15.75 × 15.75 in.} when
machine is equipped with optional runout
detector
Cutting capacity
Stack cutting (H × W)
50 × 180 mm {1.97 × 7.09 in.} to
200 × 300 mm {7.87 × 11.81 in.}
Saw blade motor 5.5 kW {7.4 HP}, 4P
Hydraulic pump motor 1.5 kW {2.0 HP}, 4P
Motors
Cutting fluid pump motor 0.18 kW {0.24 HP}, 2P
Power source 3-phase, 400 VAC ± 10%, 50 Hz
Temperature
Operating: 0 to 40°C {32 to 104 °F}
Nonoperating: –5 to 50°C {23 to 122 °F}
Environment
Humidity
Operating: 30 to 90%
Nonoperating: 10 to 95% (noncondensing)
Control circuit voltage AC 100 V, DC 24 V, DC 12 V
Dimensions (W × T × L)
HFA-400: 32 × 1.066 × 4570 mm
{1-1/4 in. × 0.042 in. × 15 ft}
HFA-400W: 38 × 1.3 × 4570 mm
{1-1/2 in. × 0.051 in. × 15 ft}
Speed 15 to 90 m/min {49 to 295 fpm}, stepless shift
Tension control
Hydraulic powered, with saw blade breakage
and slip detection functions
Side Insert 4-point support, bearing twist
Saw blade
Guide
Back Bearing, seesaw support
Vise operation Hydraulic full-stroke cylinder
Tank capacity 120 liters {31.7 US gal}
Pump type Centrifugal pump
Cutting fluid
Pump capacity
60 liters/min {15.9 US gal/min} at lift of 4 m
{13 ft}
*When automatic operation is to be performed, work must be at least 30 mm {1.18 in.} in
diameter or width.
To Next Page
Loading...
