I-16
OPTIONAL ACCESSORIES
Name Specification or type Qty
Multi-vises
Used for stack cutting and hydraulically driven together
Installed one each on front and rear vises
Clamp width:150 mm {5.9 in.} for HFA-250 and HFA-250W
180 to 300 mm {7.1 to 11.8 in.} for HFA-400 and HFA-
400W
Clamp height: 50 to 150 mm {2.0 to 5.9 in.} for HFA-250 and HFA-
250W
50 to 200 mm {2.0 to 7.9 in.} for HFA-400 and HFA-
400W
1 set
Vise pressure
control valves
Pressure adjusting range: 1.0 to 2.7 MPa {10 to 27 kgf/cm
2
, or 142
to 384 psi} for HFA-250 and HFA-250W
1.1 to 3.5 MPa {11 to 35 kgf/cm
2
, or 156
to 498 psi} for HFA-400 and HFA-400W
1 set
Runout detector
(factory option)
Digital display: 0.0 to ±99.9 mm in 0.1-mm increments
0.000 to ±9.999 inches in 0.001-inch increments
Runout tolerance:Set in both of plus and minus directions
Saw blade automatically stops when runout tolerance is exceeded
1 set
Roller table
Table length: 2 m {6.56 ft}
Roller width:330 mm {13.0 in.} for HFA-250 and HFA-250W
480 mm {18.9 in.} for HFA-400 and HFA-400W
Allowable loading mass: 1000 kg/m {7230 lb/ft}
1
Roller stand
Height adjusting range: 650 to 780 mm {25.6 to 30.7 in.} for HFA-
250 and HFA-250W
780 to 820 mm {30.7 to 32.3 in.} for HFA-
400 and HFA-400W
Roller width:220 mm {8.7 in.} for HFA-250 and HFA-250W
416 mm {16.4 in.} for HFA-400 and HFA-400W
Allowable loading mass: 600 kg {1320 lb} for HFA-250 and HFA-
250W
1500 kg {3310 lb} for HFA-400 and HFA-
400W
1
Head-end
positioning
function
(factory option)
Round bar diameter of 20 mm {0.79 in.} or less and flat bar
thickness of 12 mm {0.47 in.} or less are out of specification
Grooveless vise plate is optional
1 set
Rotating beacon
lights
(factory option)
Yellow and red beacon lights flash to indicate that machine has
stopped at end of automatic operation and at occurrence of alarm,
respectively. Green beacon light illuminates to indicate that cutting
is under way.
1
Wheel cover
open limit switch
(factory option)
Safety device to stop saw blade running when wheel cover is
opened
1 set
To Next Page
Loading...
