IV-1
Part
IV
Operation
Inspection before start of day’s work ............................................. IV-3
Turning on machine ....................................................................... IV-3
Selecting saw blade....................................................................... IV-3
Unfolding and folding saw blade.................................................... IV-4
Unfolding saw blade................................................................... IV-4
Folding saw blade ...................................................................... IV-6
Installing saw blade........................................................................ IV-8
Adjusting position of wire brush.....................................................IV-11
Adjusting position of movable saw blade guide............................ IV-12
Loading and positioning work ....................................................... IV-13
Loading work............................................................................. IV-13
Positioning work ........................................................................ IV-15
Positioning remnant for cutting further................................... IV-17
Semiautomatic positioning function........................................... IV-18
Setting cutoff length............................................................... IV-18
Semiautomatic positioning..................................................... IV-19
Adjusting cutting fluid flow rate ..................................................... IV-21
Running in new saw blade............................................................ IV-22
Stack cutting ................................................................................. IV-23
Stacking workpieces.................................................................. IV-23
Using multi-vises (optional) ....................................................... IV-24
Runout detector (optional) ............................................................ IV-27
Setting runout tolerances .......................................................... IV-27
(Continued on next page.)
To Next Page
Loading...
